How to improve the productivity of micro powder mill

 

 

Clirik experts say,actually the reason is very simple,  Let's look at these causes.

 

1, the moisture of materials.

 

The Moisture of raw material is too large, micro powder mill milling process can easily produce a fine powder adhesion, even on the blocking device components, reducing production efficiency ultra-fine milling machine, while the finished material during transmission is also very likely to cause circulation duct, analyzers, the discharge opening at the device plug, product output can not reach the predetermined requirements. Therefore, an appropriate reduction in the ore grinding chamber ore material moisture, ultrafine mill can also increase productivity.

 

2, the hardness of the material.

 

Increases the hardness of the material, in order to sufficiently abrasive material, grinding pressure grinding roller mill ring to the resulting increased accordingly, but this time the loss of equipment will also increase, resulting in the production capacity of the apparatus is reduced, production also finished lower.

 

3, Electric current.

 

Increasing the current efficiency ultrafine mill will naturally increase can be roughly estimated tonnage of grinding load and mounted more powerful motors. It should be noted that the load current can not exceed the maximum rated power, otherwise it will suffer huge losses.

 

4, grinding roller and grinding ring quality.

 

As the production of micro powder mill is the principle by rolling action of the roller mill ring to achieve a fine powder material production, so the quality of the grinding roller and grinding ring better, producing more fully the role of the material, if the mill roller mill ring appeared in a short time after use badly worn, you can not achieve sufficient abrasive materials, low productivity, production capacity will naturally be reduced.